11
5. Disable supervision for the RF Jam detect zone by turning the relevant option off in section [82], [83], [84] or [85].
(See section 4.3 for more information.)
6. RF jamming detection is now enabled. To exit Installer programming, press [#].
NOTE: For UL Listed installations, the RF Jam feature must be enabled - Section [804], subsection [90], Option [7]
OFF. Ensure the wireless bit is enabled and jam bit in section [90] is disabled.
4.5 RF5132-433 Software Default
Returning the RF5132-433 programming to factory default settings is a quick way to remove all the enrolled devices
from the system and reset all the programming in section [804].
NOTE: Performing this procedure will not change any programming sections except [804]. Resetting the control
panel to factory default settings will not return the RF5132-433 module to factory default settings.
To restore the RF5132-433 programming to the factory default settings:
1. Enter [*][8] [Installer’s Code].
2. Enter programming section [996].
3. Enter the Installer’s Code, followed by [996] again. The software for the RF5132-433 will be restored to its factory
default settings.
4. To continue programming the unit, exit installer’s programming by pressing [#] and then re-enter installer’s
programming by entering [*][8] [Installer’s Code].
For instructions on restoring the default programming of the control panel or any other connected module, see your
system Installation Manual.
4.6 Deleting Wireless Devices
To remove a wireless device from the system, follow the guideline for enrolling a wireless device (see section 3.2).
Program the ESN as [000000]. The wireless device for the zone will be removed.
NOTE: You may need to remove power from the panel in order to clear troubles caused by deleted zones.
Now that you have completed all RF5132-433 related programming, you can test and mount
the receiver and devices. See section 5 for more information.
To Next Page
Loading...
