12
Keypad Configuration
Figure 10 - Keypad Configuration
Figure 11 - Brightness Settings
Changing Brightness
More > User Options > Keypad Config > Brightness
Use the slide bar to adjust brightness to the desired setting. To exit, press the Back or Home button.
Night Light Brightness Control
More > User Options > Keypad Config > Brightness > Nightlight
You can use this button to with a slider that will determine the brightness of the keypad “night light”.
When this slider is in the position of darkest (left hand side of the slider), the night light feature will be
disabled. If the slider is all the way to the right, then the night light will be on as bright as possible.
1. Use the slide bar to select the desired brightness of the night light backlighting.
2. To exit press the Back or Home button.
Verbal Prompts
More > User Options > Keypad Config > Verbal Options
1. A button toggles verbal options on and off. When Verbal Chime is set to on, the WTK5504 will
speak the zone label words (e.g., ‘Laundry Room Window’) when the zone chimes. When Ver-
bal Prompt is set to on, the WTK5504 will speak system prompts (e.g., ‘Quick Exit in progress’).
2. T
o exit press the Back or Home button.
Adjusting the Buzzer Frequency (Tone)
More > User Options > Keypad Config > Volume Setting > Buzzer Fre-
quency
This allows you to select different tones of the keypad beeps. Use the slide bar to adjust the tone to the
desired setting.
Changing the Buzzer Volume
More > User Options > Keypad Config > Volume Setting > Buzzer Volume
To Next Page
Loading...
Need help?
General
