Water Dots are placed on every shelf and door panel to indicate if moisture is present or has got inside the unit. The
Dots are originally white in color but will turn red when water is absorbed.
WARNING: Condensation of water may occur if the system is unpacked in a very low temperature environment. In
this case it is necessary to wait until the system is fully dry inside before proceeding with the connection of any power;
otherwise an electrical shock hazards might exist. Installation and wiring must be performed in accordance with the local
electrical code and under the guidance or instructions of professional personnel.
Operating Temperature: 0º to 40ºC (32º to 104ºF); Storage Temperature: -20º to 60ºC (-4º to 140ºF)
Note: Per code requirements, leave 3” on each side of the cabinet (including the back)
and 3 foot clearance in front (Refer to Figure 1). Storage of the system should be in a
cool and dry area with the unit being upright and covered. The warranty can be affected
if the unit is stored for more then 3 months without charging thebatteries.
Title: Micro
Doc No.: 018-1000-02
Description: Emergency Lighting Inverter User’s Manual Date: 07/26/2016
Rev: NR
1.877.DSPM.POWERPhone : 1.877.377.6769-
909.930.3335Fax:
www.dspmanufacturing.com
Website:
techsupport@dspmanufacturing.com
E-Mail:
Title: Micro
Doc No.: 018-1000-02
Description: Emergency Lighting Inverter User’s Manual Date: 07/26/2016
Rev: NR
1.877.DSPM.POWERPhone : 1.877.377.6769-
909.930.3335Fax:
www.dspmanufacturing.com
Website:
techsupport@dspmanufacturing.com
E-Mail:
23
Figure 5
Title: Three Phase 208 or 208Y/120Vac
Doc No.: 018-6000-00
Description: Emergency Lighting Inverter User’s Manual
Rev: NR
Date: 08/12/2022
Phone :
Website:
E-Mail:
Fax:
1.877.DSPM.POWER-1.877.377.6769
1.877.DSPM.POWER-1.877.377.6769
www.dspmanufacturing.com
techsupport@dspmanufacturing.com
To Next Page
Loading...
