EasyManua.ls Logo

DSR DSR15 - Moving and Storage, Specifications, Troubleshooting; Technical Specifications Overview; Common Troubleshooting Solutions

Default Icon
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
12. MOVING AND STORAGE INSTRUCTIONS
12.1 Store the charger unplugged, in an
upright position. The cord will still conduct
electricity until it is unplugged from the
outlet.
12.2 If the charger is moved around the shop or
transported to another location, take care
to avoid/prevent damage to the cords, clips
and charger. Failure to do so could result in
personal injury or property damage.
13. SPECIFICATIONS
Input ................................................................................................230-240V~50 Hz, 2.3A
Output .............................................................................................. 6/12V
2A, 10A, 15A
Weight ..................................................................................................................... 1.28 kg
Reverse polarity protection ........................................................................................... Yes
Operating temperature .......................................................................................... 0°-40° C
14. TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
CONNECTED LED
is not on.
The battery is not connected
correctly.
Battery voltage is at zero volts.
Check for proper connection to the
battery.
Turn off everything in the car and
try to connect again.
CHARGING LED is
blinking.
Charger is in abort mode.
Battery is sulfated.
Battery is bad.
Unplug the charger from the AC
and plug it back in.
Use (Desulfation Mode) for 8
hours.
Have the battery checked.
CHARGED LED
is on, but battery is not
fully charged.
Surface charge voltage is high.
Battery voltage is very low and the
charger detects it as 6V, not 12V.
Replace the battery.
Unplug the charger from the AC
and plug it back in.
All LEDs are lit in an
erratic manner.
A button may have been pressed
while the charger was being
plugged in.
Unplug the charger from the
AC and plug it back in, without
touching the control board.
15. DISPOSAL INFORMATION
This product should not be disposed with other household wastes. To prevent possible
harm to the environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return your used
device, please use the return and collection systems or contact the retailer where the
product was purchased. They can take this product for environmental safe recycling.

Related product manuals