DT SWISS RATCHET EXP User Manual

14
2.11 SCREWING THE THREADED RATCHET WITH THE BEARING INTO THE HUB SHELL
1. Slightly grease the threaded ratchet and
the thread of the hub shell with universal
grease.
2. Put the installation cylinder into the vise.
3. Insert the axle into the installation cylinder
with the short side rst.
4. Push the hub shell onto the installation
cylinder with the drive side facing upwards.
5. Slide the threaded ratchet with the ball
bearing onto the axle.
→ The toothing of the threaded ratchet
must face upwards.

DT SWISS RATCHET EXP Specifications

General

Brand	DT SWISS
Model	RATCHET EXP
Category	Switch
Language	English