16
13. Remove the hub from the mounting / dismounting tool and put the tool out of the vice.
2.12 MOUNTING THE BALL BEARING AT THE NON DRIVE SIDE
1. Make sure that the axle is in the hub with
the long side rst.
2. Grease the bearing seat and the axle with
universal grease.
3. Push a new bearing on the axle with the
colored side facing outwards.
4. Clamp the mounting / dismounting tool for
the threaded ratchet into the vice.
5. Put the hub on the tool in the vice.
6. Put the installation cylinder onto the
bearing.
7. Tap in the ball bearing carefully with slight
hammer strokes.
HXTXXX00N5314S /
HXTXXX00N5025S
HXTXXX00N8387S
To Next Page
Loading...
Need help?
General