To Next Page

To Previous Page

PCB Control card.

NOTE: If no beams are fitted, CL and TX CMN on the PCB by the Safety beams MUST be bridged.

Note; 1) The 12V OUT on the 600 PCB is a regulated voltage up to 12Volt DC.

2) Please ensure that the auxiliaries connected to the 12 volt auxiliary output do not exceed

500 m/Amps in total. (If so, remove from aux. output and connect directly to battery)

Questions and Answers:

Need help?

Do you have a question about the DTS 600 Elite and is the answer not in the manual?

DTS 600 Elite Specifications

General