9- PERIODIC CLEANING
9.1- Front glass
Even a fine layer of dust can substantially reduce the luminous output . Regularly clean the front
glass using a soft cotton cloth, dampened with a specialist lens cleaning solution.
9.2- Fan and air passages
The fan and air passages must be cleaned approximately every 6 weeks. This periodic cleaning will
depend of course, on the conditions in which the projector is operating. Suitable instruments for
performing this type of maintenance are a brush and a common vacuum cleaner or an air
compressor. If necessary, clean the fans and air passages more frequently.
10- PERIODIC CONTROLS
Attention
Disconnect mains power prior to removing the projector housing.
Lamp
The lamp should be replaced if there is any visible damage or deformation due to heat. This will
help to avoid the danger of the lamp exploding.
Electrical components
Check all electrical components for correct earthing and proper connection of all connectors;
refasten them if necessary.
Fuse replacement
Locate the fuse, which protects the lamp and electronics, in the rear panel base of the DMX
STROBE.
Using a multimeter, test the condition of the fuse, replacing it with one of equivalent type if
necessary.
11
DMX STROBE
To Next Page
Loading...
Need help?
General
