3- VOLTAGE AND FREQUENCY
The DMX STROBE operate at 230 VOLT 50 or 60 Hz.
4- INSTALLATION
DMX STROBE should be ceiling mounted.
For ceiling mounted installations, we reccomend the use of appropriate clamps to fix the unit to the
mounting surface.
The supporting structure from which the unit is hung should be capable of bearing the weight of the
unit, as should any clamps used to hung it.
4.1- Safety cable
We recommend the use of a safety cable or chain connected to the DMX STROBE and to the suspension
truss in order to avoid the fixture accidentally falling should the main fixing point fail. Make sure that the
iron cable or chain can bear the weight of the entire unit.
4.2- Protection against liquids
The projector contains electric and electronic components which should under no circumstances come
into contact with oil, water or any other liquid. The proper unit functioning would be compromised
should this occur.
4.3- Risk of fire
Each fixture produces heat and must be installed in a well-ventilated place. The minimum recommended
distance from flammable material is 1 MT.
Minimum distance from the object being illuminated is 2 MT.
4.4- Forced ventilation
You will note, on inspection, that the unit features various air inlets and cooling fan. These should, under
no circumstances, be blocked or obstructed whilst the projector is in operation.
Doing so could cause the fixture to seriously overheat thereby compromising its proper operation.
4.5- Ambient temperature
The projector should never be installed in places that lack a constant air flow. The ambient temperature
should NOT exceed 40°C.
6
DMX STROBE
To Next Page
Loading...
Need help?
General
