To Next Page

To Previous Page

6.1-DMX Addresses

Dmx STROBE 1500 can be used in two different modes: 2 or 4 DMX (default) channels.

If you want to use the DMX STROBE in 2 channels mode, select the 2 CH mode from the MODE menu

and set the following addresses on the mixer:

Projector 1 A001

Projector 2 A003 If you want to select the next projector, just add “2”

Projector 3 A005

….. A….

projector 6 A011

If you want to use the DMX STROBE in 4 channels mode, select the 4 CH mode from the MODE menu

and set the following addresses:

Projector 1 A001

Projector 2 A005 If you want to select the next projector, just add “4”

Projector 3 A009

….. A….

Projector 6 A021

6.2-Selecting the DMX address

1) Press the UP-DOWN key until you reach the required DMX channel. The numbers on the display will

start to flash (but the new DMX address hasn't yet been set).

2) Press ENTER to confirm your selection. The numbers on the display will stop flashing and the

projector is now setted to the new DMX address.

TRICKS:

if you keep pushed the UP or DOWN keys, the channels are calculated more quickly and you get a

faster selection.

DMX STROBE

Questions and Answers:

Need help?

Do you have a question about the DTS Dmx Strobe 1500 and is the answer not in the manual?

DTS Dmx Strobe 1500 Specifications

General