DTS Wonder D - Smooth

17
SMOOTH VALUE
Range = 0 – 20
Default = 4
GAMMA CORRECTION
LINE = Linear current output
QUAD = Quadratic light
output (Default)
OUTPUT FREQUENCY
Range: 600 Hz – 10 KHz
Default = 600 Hz
BOOST
OFF = 800mA (Default)
ON = 1000mA
SMOOTH
LED
MENU ENTER DOWN UP
4
GAMMA CORR.
LED
MENU ENTER DOWN UP
QUAD
FREQUENCY
LED
MENU ENTER DOWN UP
600 Hz
BOOST
LED
MENU ENTER DOWN UP
OFF
MENU ENTER DOWN UP
LIVE-TOUR
SETTING
LIVE-STUDIO
SYSTEM INFO
UNIT LIFE: 0124H
LED: R10
ZOOM: R11
PT: R11
MODEL: WONDER D FPR
MENU ENTER DOWN UP
RDM: 000009B4
12- DISPLAY FUNCTIONS
LED
SMOOTH: This menu allows to select
the value of the delay (in milliseconds)
for RGBW and Dimmer channels
reaction to DMX or program variation.
4 = 25 ms delay (fast response)
20 = 250 ms delay (slow response)
GAMMA CORRECTION
This menu allows to select between
Linear current output or Quadratic
current output for LEDs.
OUTPUT FREQUENCY
This menu allows to adjust the PWM
frequency value (Hz) in order to reduce
flickering in the process of your camera
recordings.
BOOST
This menu allows to increase the
LEDs current from 800mA to 1000mA.
Live-Studio setting
System Info
Up-Down
Menu
Up-DownENTER
ENTER
SYSTEM INFO
Unit life time; LED Driver,
Zoom and Pan&Tilt PCBs
software version; unit model
and RDM ID
Up-Down
Menu
Up-DownENTER
ENTER
Up-Down
Menu
Up-DownENTER
ENTER
LIVE-TOUR mode = High
fans speed: the LEDs always
work at maximum power
(Default)
STUDIO mode = Low fans
speed for a very low noise
operation