Dualit BEAN TO GO User Manual

22 23
DESCALER
WATER
1
Ensure the Water Tank
is lled with water before
adding descaler. Ensure
that a compatible descaler
is used and that any water
softners are removed before
descaling.
DESCALE
HARD WATER WILL CAUSE LIMESCALE BUILD-UP, RESULTING IN BLOCKAGES THAT
CAUSE PERMANENT DAMAGE. See Limescale Warning on page 8. The machine will display
a warning when descale is overdue. It is essential that a compatible descaler is used -
visit www.dualit.com/accessories for descaler options. See page 10 for Button and Warning
Symbols. The descale process takes approximately 20 minutes.
Place a 2L container
underneath the Coffee
Nozzle and Steam Nozzle.
Plug in Power Cord and
press the Power Button
to turn the machine on.
Water will purge through
the Coffee Nozzle.
FILL WATER TANK
AND ADD
DESCALER
Press and hold the Power
and Espresso Buttons
for 5 seconds. Two beeps
will sound and the Descale
Warning / Espresso Button
will ash. Press the Espresso
Button to start descale
process.
4 5
The Descale Warning
symbol will ash during the
descale process. Stand away
from the machine during this
process. Liquid will dispense
from the Nozzle and
Steam Wand intermitently.
Caution: Hot.
When the Water Tank
Warning and Espresso
Button ash, remove
the Water Tank, empty
and rinse to remove all
remaining descale solution.
6
Fill the Water Tank with fresh
water and install back in the
machine.
The machine will automatically
start to dispense water out of
the Nozzle and Steam Wand
and will switch off once the
dispense cycle is complete.
Ret water softner.
FINISHREMOVE WATER
TANK
SELF CLEAN
2
Ensure a 150ml container
is below the Steam Wand.
When the machine is turned
on, hold down the Power
Button and Lungo Button
for 5 seconds. Two beeps
will sound.
EMPTY SYSTEM
If you are not going to use your machine for a long period of time, it is
recommended that you use the Empty System Function. This process will
drain all of the water out of the system through the Steam Tube, preventing
the chance of limescale build up. See page 10 for Button and Warning
Symbols.
When the Empty System
warning is displayed, remove
the Water Tank and place
on the side.
REMOVE WATER
TANK
Once the Water Tank is
removed, water will pour
out of the Steam Nozzle.
The machine will then turn
off.
Ensure a 150ml container is
below the Coffee Nozzle.
When the machine is turned
on, hold down the Power
Button and Hot Water
Button for 5 seconds. Two
beeps will sound.
The machine will dispense
a small amount of water
through the Coffee Nozzle
and into the container
before returning back to the
menu.
MANUAL RINSE
It is recommended that a Manual Rinse is conducted at the end of each day the machine is
used. This process ushes water through the Coffee Nozzle, removing coffee residue from
inside the machine and therefore reducing the chance of mould build up. See page 10 for
Button and Warning Symbols.
U
N
P
L
U
G
W
H
E
N
N
O
T
I
N
U
S
E
S
W
I
T
C
H
O
F
F
&
3
ACTIVATE
1
ACTIVATE
3
EMPTY SYSTEM
1
ACTIVATE
2
RINSE
2
TURN MACHINE
ON

Dualit BEAN TO GO Specifications

General

Brand	Dualit
Model	BEAN TO GO
Category	Coffee Maker
Language	English