12
ASSEMBLY
• Never handle the generator, electronic devices, or any cord while standing in water, while barefoot, or when
hands or feet are wet.
• Always keep the generator dry. Never operate generator in rain or under wet conditions.
• Never plug electronic devices into generator having frayed, worn, or bare wires. Never touch bare wires or make
contact with receptacles.
• Never permit a child or unqualified person to operate generator. Keep children a minimum of 10 feet away from
the generator at all times.
• If using the generator for back up power, notify the utility company.
• If connecting generator to a building’s electrical system for standby power, you must use a qualified electrician to
install a transfer switch. Failure to isolate the generator from the power utility could result in serious injury or death to
electric utility works.
• When using extension lines or mobile distribution networks the total length of lines for a cross section of 1.5 mm²
should not exceed 60 m; for a cross section of 2.5 mm² this should not exceed 100 m.
• The generating set must not be connected to other power sources except with accessory advised by the
manufacturer or other generators with the same model.
• Save these instructions. Refer to them frequently and use them to instruct others who may use this product. If
you loan someone this product, loan these instructions also.
• Due to high mechanical stresses, only tough rubber sheathed flexible cable (in accordance with IEC60245-4) or
the equivalent should be used.
This generator produces a very high voltage which could result in burn or
electrocution causing serious injury or death.
Connecting Generator to an Electrical System
• If connecting generator to a building’s electrical system for standby power,
The power
from the generator must be isolated from the circuit breaker or alternative
power source. The connection must comply with all electrical codes and
applicable laws.
Never directly connect generator
to a household power source.
UNPLUG
you
must
use
a
qualified
electrician
to
install
a
transfer
switch.
To Next Page
Loading...
