23
MAINTENANCE
Changing Oil
• Place generator on a level surface.
• Run the generator for several minutes until the engine is warm. Turn off generator.
• Remove screws, then remove outer casing.
• Remove the crankcase dipstick.
• Place an oil pan underneath the engine. Tilt generator to collect used oil. Allow oil to drain completely.
• Return generator to a level surface.
•
(Crankcase Dipstick hole).
• Use a clean rag to wipe up any spilled oil.
• Replace crankcase dipstick.
• Reinstall outer casing and tighten screws.
Make sure no foreign matter enters the crankcase
CAUTION!
the engine.
CAUTION!
Recommended Engine Oil:
SAE 10W-30
Recommended Engine Oil Grade: API Service SE type or higher quality
of engine oil. Engine Oil Quantity: 1.1L
Carefully
add
4-
Cycle
engine
oil
(SAE
1
OW
-
30)
to
empty
reservoir
until
oil
reaches
the
outer
edge
of
the
oil
fill
hole
A -
Oil
di
pstick
B -
Drain
C -
Oil
fi
ll
B
IA
CAUTION
I
Do
not
tilt
generator
when
adding
oil.
This
could
result
in
overfilling
which
could
damage
[IA
cAu110NI
To Next Page
Loading...
