E
48
2) Check that the stop switch (1, fig. 37) is positioned to
(RUN), then press the starter button (2).
This model is equipped with a servoignition system.
To achieve assisted engine starting, press the button (2)
and release it immediately.
Pressing the button (2) operates automatic engine starting
for a maximum period of time that varies depending on
engine temperature.
When the engine has started, the system prevents the
starter motor from turning over.
If the engine fails to start, allow at least 2 seconds before
pressing the starter button (2) again.
Let the engine start without using the throttle control.
Note
If the battery is flat, the system will automatically
prevent the starter motor from turning over.
Important
Do not rev up the engine when it is cold. Allow some
time for oil to reach all points that need lubricating.
1
2
fig. 37
DUCum_1000DS####03_###e.book Page 48 Wednesday, March 12, 2003 4:33 PM
ProCarManuals.com
To Next Page
Loading...
