Ducati Multistrada 1000ds - Page 67

E
67
Low beam (upper)
Disconnect connectors (4) from the clamps on the bulb.
Release clip (5) from bulb socket by pushing down and
then squeezing its ends (fig. 55).
Pull the clip up (5).
Remove the burnt-out bulb (6) and replace it with a new
one, do not touch the transparent body of the bulb (fig. 56).
Note
Be careful to hold the new bulb at the base only.
Never touch the transparent body with your fingers or it
will blacken resulting in reduced bulb brilliancy.
6
fig. 56
4
5
fig. 55
DUCum_1000DS####03_###e.book Page 67 Wednesday, March 12, 2003 4:33 PM
ProCarManuals.com