10
Plug in the CN1 connector already cabled
8. From control panel provide the unlock command on IN1 (remove the positive 12 V)
9. Press K1 button until the plunger back to its initial position
10. Block Peperosso using IN1 (provide a positive 12 V)
11. Remove jumpers JP1 e JP2 (in this way both tamper of Peperosso are activated)
12. At this point make a functioning test using the test spray can (containing water, see “Test”
paragraph)
At the end of test block Peperosso using IN1 (provide a positive 12 V)
13. Peperosso must stay at rest with the plunger completely back and settled
Only in this position is possible to fix the spray cans with the straps (fig. 6)
In this phase, to avoid unwanted nebulisations, (caused by error on wiring or moved on CN1),
remove the CN2 motor connector, in this way the plunger is mechanically blocked allowing a secure
installation
14. Close the cover
15. Plug in the CN2 motor connector
16. Peperosso is ready to be used
To Next Page
Loading...