5
Functioning
The electronic board analyses the wired input commands to safely determine the need for spray. In positive
case, a mechanical system compress the sprays that nebulize the chili pepper based gas.
The active principle will spread in an area of about 100 m
2
(unique environment), causing irritation on skin
and mucosa, cough, lacrimation, heavy abundance of mucus and intense burning sensation, persuading
the intruder to leave immediately the area.
Peperosso can work in two different modes to avoid unwanted nebulization:
Nebulisation driven by IN3
THE SECURITY SYSTEM MUST BE ARMED…
Peperosso is connected to control panel (input IN1) and enable its working only when the alarm
system is armed
…IN CASE OF ALARM NEBULISATION IS READY…
When the system is in alarm the control panel signals it to Peperosso (input IN2) that prepares
nebulisation: the gas is not yet emitted, depends on input IN3 state
…AN INTRUDER CAUSE NEBULISATION TO START
Peperosso verify if the confirm input (input IN3) signals a detection: it’s the confirm an intruder is
near and thus gas nebulisation can start
It’s possible to connect input IN3 to a remote control system (example: surveillance system) to
enable nebulisation from remote
Instantaneous nebulisation
THE SECURITY SYSTEM MUST BE ARMED…
Peperosso is connected to control panel (input IN1) and enable its working only when the alarm
system is armed
…AS SOON AS AN ALARM STARTS THE GAS IS NEBULIZED
When the system is in alarm, the control panel signals it to Peperosso (input IN2) that prepares
nebulisation: the gas is nebulized. The confirm input (input IN3) must be correctly connected
To Next Page
Loading...