Durabrand DB1200 - General Operation; Faceplate Removal; Power On;Off; CD Mode

General Operation
5
DB1200 OPERATION
Press RELEASE and pull away from the left side to
remove. To re-install, insert right side of faceplate first
then push left side to secure.
*For semi-permanent faceplate installation, remove trim ring and install
supplied Phillips head #1 screw through left side of mounting frame into
faceplate.
Press PWR to turn the unit on. Inserting a CD will turn the
unit on automatically. Press PWR to turn the unit off.
Insert a CD or press
l
/ II to begin or resume playback.
Press PWR or BAND to begin or resume tuner operation.
Press BASS to activate and deactivate bass boost curve.
Activating this feature will enhance the bass frequencies
when listening to music at low volumes.
Adjust volume using VOL s or VOL t (00-46).
Press DISP to display the clock. The radio frequency
(tuner mode) or CD track/elapsed time (CD player mode)
show by default.
Press DISP to display the clock, then release. Press and
hold DISP for 2 seconds, the clock will begin to flash.
Press TUNE << to adjust the hours and TUNE >> to
adjust the minutes. Clock settings will be saved after 5
seconds.
The clock will display 12-hour AM/PM time in U.S.
frequency spacing mode (PM 10:00). In European
frequency spacing mode, the clock will display 24-hour
time (22:00).
Faceplate Removal
Power On/Off
CD Mode
Tuner Mode
Bass Boost
Volume
Display
Set the Clock
12/24-hour Clock