7. Locate the scale plastic aerial mast and wing pitot tube and glue each in place
on the model one at a time as shown below. Do NOT use an excessive amount of
glue but DO allow the glue to become tacky before gluing these parts in place.
8. The final stage of assembly is to test fit the Me-163 droppable dolly (landing
gear) to the fuselage. Simply drop the dolly into the slot on the underside of the
fuselage and you are done, the magnets will take care of the rest! The scale
release system is covered in the next steps of this manual.
6
To Next Page
Loading...
