5
12. The basic assembly of your MFX Racer is now finished. Please perform a
final check on all screws and components ensuring they are secure and
firmly in place.
Before getting started on the set up, if you haven't already done so then bind your receiver to your
transmitter. Please refer to your transmitter m
anual for the operation procedures. Make sure all the
control sticks are in neutral position, (Rudder, elevator and ailerons), also ensure the throttle is in
the OFF position. Turn on the transmitter and make sure all the trims and the sub
trims (for a computerized TX) are in the neutral position, then power up the ESC and servos. For
safety reasons, it's advised that this is done with the propeller removed.
SETTING UP YOUR MODEL:
To Next Page
Loading...
