What to do if DURASTAR Air Conditioner's evaporator coil inlet temperature sensor T2 is in open circuit or has short circuited?
If your DURASTAR Air Conditioner's evaporator coil inlet temperature sensor T2 is in open circuit or has short circuited, refer to service solution TS05-IDU.
Why is my DURASTAR DRAD24F1A's heating not working well?
If your DURASTAR Air Conditioner isn't heating well, it could be due to a few reasons. Extremely low outdoor temperatures can affect heating performance; consider using an auxiliary heating device. Cold air entering through doors and windows can also be a factor; ensure they are closed during use. Additionally, low refrigerant levels due to leaks or long-term use could be the issue; check for leaks and replenish the refrigerant as needed.
What to do if indicator lamps are flashing on my DURASTAR DRAD24F1A?
If the indicator lamps on your DURASTAR Air Conditioner continue to flash or error codes appear, wait about 10 minutes to see if the problem resolves itself. If it doesn't, disconnect the power, then reconnect it, and turn the unit on. If the problem persists, disconnect the power.
What to do if my DURASTAR DRAD24F1A Air Conditioner is not working?
If your unit isn't working, first check for a power failure and wait for the power to be restored. Ensure the power is turned on. Replace the fuse if it's burned out. Replace the remote control batteries if they are dead. If the unit's 3-minute protection has been activated, wait three minutes after restarting it. Finally, check if the timer is activated and turn it off.
What to do if DURASTAR Air Conditioner's outdoor fan speed is operating outside of the normal range?
If your DURASTAR Air Conditioner's outdoor fan speed is operating outside of the normal range, refer to service solution TS04- ODU.
Why is my DURASTAR Air Conditioner not cooling properly?
If your DURASTAR Air Conditioner isn't cooling well, several factors could be at play. The temperature setting might be too high; try lowering it. A dirty heat exchanger on either the indoor or outdoor unit can also cause this—clean it to improve performance. Additionally, check and clean the air filter if it's dirty. Ensure that the air inlet and outlet aren't blocked; if they are, turn off the unit, remove the obstruction, and turn it back on. Make sure all doors and windows are closed to prevent warm air from entering. Reduce heat from sunlight by closing windows and curtains. A refrigerant leak or depletion could also be the issue; check for leaks and top off the refrigerant if needed. Finally, too many heat sources in the room, like electronics, can strain the unit; try to reduce thes...
What to do if DURASTAR DRAD24F1A's outdoor room temperature sensor T4 is in open circuit or has short circuited?
If your DURASTAR Air Conditioner's outdoor room temperature sensor T4 is in open circuit or has short circuited, refer to service solution TS05- ODU.
What does it mean if my DURASTAR DRAD24F1A displays outdoor unit EEPROM parameter error?
If your DURASTAR Air Conditioner is showing an outdoor unit EEPROM parameter error, refer to service solution TS01- ODU.
What does it mean if my DURASTAR DRAD24F1A Air Conditioner displays IPM malfunction or IGBT over-strong current protection?
If your DURASTAR Air Conditioner is experiencing IPM malfunction or IGBT over-strong current protection, refer to service solution TS09-L.
What to do if DURASTAR DRAD24F1A Air Conditioner displays current overload protection?
If your DURASTAR Air Conditioner is showing a current overload protection error, refer to service solution TS08-L- INV.
Safety guidelines for operating, cleaning, and maintaining the unit to prevent injury and damage.
Precautions for using the unit, including power management and environmental factors.
Safety warnings for troubleshooting, advising to turn off the unit if certain conditions occur.
Addresses common issues like poor cooling/heating, frequent start/stop, and indicator lamps with causes and solutions.
Lists various error codes (E0-E5, EC, F0-F6, P0-P4, P6) and their corresponding error descriptions.
General| Cooling Capacity | 24000 BTU/h |
|---|---|
| Refrigerant | R410A |
| Noise Level (Outdoor Unit) | 55 dB(A) |
| Type | Split System Air Conditioner |
| Power Supply | 220-240V, 50Hz |
| Operating Temperature Range (Cooling) | 18-43°C |
To Next Page
