Duratech Sun Spring - Error Interface; Error Parameter Interface

15
ENG
Number of the error in the heat pump:
Number of the error. The following can be found:
6.6 Error interface
6.7 Error parameter interface
Count of errors in the heat pump:
Number of errors. The following can be found:
Err:
Notication of error.
Error notication
name:
Name of error in
the heat pump. The
following can be found:
UP & DOWN:
Press to enter error
parameter interface and
see which errors occur.
UP & DOWN:
Press to toggle between
errors.
Ambient temperature
sensor error
Evaporator temperature
sensor error
Liquid line temperature
sensor error
Water inlet temperature
sensor error
By pressing UP & DOWN simultaneously the Error parameter interface we’ll be entered. Here it is
shown which specic errors have occurred. A complete list of errors can be found in the error list,
section 6.8.
When an issue is detected the heat pump will try to solve it by analyzing several parameters,
restarting components and bypassing electronics. An error is shown on the display when the
program can not solve the issue.
The heatpump will stop working and can only be restarted by unplugging the RCD. If the pump still
shows the error after that, please contact your service centre or similarly qualied person.