6
6
6
APPLY THE DECALS
SPEED CONTROL SET UP
• Connect the battery pack to the ESC. Turn on the Tx,
and then the ESC.
• The Sprint
™
2 sets up automatically.
• Do not touch the throttle trigger for 2-3 seconds.
• The green light will fl ash and then glow steadily.
• Ready to use!
• Do not run the car near water! Never allow water, moisture, or any foreign material inside the case of the ESC.
• Never use more than a 6-cell, 7.2 volt battery pack.
• Do not attempt to connect the battery pack to the ESC in reverse, as permanent damage to the ESC could result.
• Never cut or splice the ESC input wires. Do not connect a battery to the receiver’s (Rx) “battery” slot. The Rx receives
power through the ESC itself which plugs into the Rx’s throttle channel slot.
• Always disconnect the battery pack from the ESC when not in use.
• Be careful not to touch the heat sink during use as it can become very hot.
• Install the wing by pressing the two wing wires into the two wing
mount holes in the top of the rear shock tower.
• Carefully remove the body’s clear
plastic protective covering.
• Decal the body to your liking. Use
the photos on the box as a reference.
• Install the body onto the chassis
using two body clips.
To Next Page
Loading...
