❏ Step 3. Snap in place the (4) body washers onto the (4)
body mounts.
❏ Step 4. Trim the body mounts under the body mount
brackets.
❏ Step 1. Bundle all of the wires around the receiver
together with a tie-strap or a twist-tie (not included in the kit).
❏ Step 2. Remove the clear covering from the outside of
the body.
❏ Step 3. Apply decals to the body if desired. For decal
placement, see the photos on the box top.
❏ Step 4. Mount the body on the body posts. Use a body
washer on each body post and then secure the body to the
truck with (4) body clips.
Congratulations, you have completed assembly! Before
running your new truck, please take the time to carefully
read the instructions for running and breaking-in the engine.
Make sure you follow the safety precautions and most of
all...HAVE FUN!
The High-Speed Needle
The high-speed needle is sticking up from the side of the
carb. It is located in the brass housing, just above the fuel
SECTION 9: CARBURETOR SETTINGS
SECTION 8: FINISHING
11
To Next Page
Loading...
