❏ 3. Send written instructions which include: a list of all
items returned, a THOROUGH explanation of the problem,
the service needed and your phone number during the day.
If you expect the repair to be covered under warranty, be
sure to include a proof of date of purchase (your store
receipt or purchase invoice).
❏ 4. Also be sure to include your full return address.
All pictures, descriptions and specifications found in this
instruction manual are subject to change without notice.
DuraTrax maintains no responsibility for inadvertent errors
in this manual.
The DuraTrax Nitro Starter Pack (DTXP0200) contains
fuel, fuel bottle, glow plug starter, glow plug wrench
and glow plug.
To operate the Overdrive ST the following items are required:
❏ 1. Fuel (DuraTrax Red Alert
™
fuel-DTXP0520)
❏ 2. Extra Glow Plugs (DTXG3001)
❏ 3. Glow Plug Wrench (DTXR1170)
❏ 1. #2 Phillips head screwdriver (DTXR0124)
❏ 2. Flat blade screwdriver (DTXR0158)
❏ 3. Air Filter Oil (DTXC2465)
❏ 1. Turnbuckle wrench
❏ 2. Nut driver (4-way)
❏ 1. Install the transmitter antenna by screwing it into the
hole on the top of the transmitter.
❏ 2. Slide open the battery door on the bottom of the
transmitter. Place 8 “AA” batteries into the holder in the
configuration molded into the plastic on the battery holder.
Reinstall the battery door.
❏ 3. Turn on the transmitter using the switch on the side
(see photo step 1). The red light on the side of the
transmitter should light up. If there is no light on, turn the
transmitter off and check to ensure that the batteries are
making contact with the metal contacts in the battery holder.
Make sure the batteries are installed correctly. Turn the
transmitter on and check for the red light. If the red light
appears, turn off the transmitter. If the red light blinks, the
batteries are low and should be replaced.
PREPARING THE RADIO SYSTEM
INCLUDED TOOLS FOR
MAINTENANCE AND TUNING
TOOLS NEEDED FOR COMPLETION
REQUIRED ITEMS FOR OPERATION
SPECIFICATION & DESCRIPTION CHANGES
3
To Next Page
Loading...
