Duratrax Warhead - FINISHING THE WARHEAD; TRANSMITTER PREPARATION; RECEIVER BATTERY INSTALLATION

4
FINISHING
FINISHING
THE
THE
W
W
ARHEAD
ARHEAD
• Remove the receiver battery holder.
• Install (4) “AA” batteries.
• Reinstall the receiver battery holder and lid.
TRANSMITTER PREPARATION
RECEIVER BATTERY INSTALLATION
• Install eight “AA” batteries into transmitter.
• Insert the antenna into the top of the transmitter and tighten.
• Turn the transmitter on and check the battery light. If the red light glows
steady, turn off the transmitter. If the red light blinks, the batteries are low
and should be replaced.