DURAVIT SensoWash Slim - Power Supply; Switch Sensowash on; Operating; Switching the Sensowash on; off

27
EN
Power supply
> Connect the main power supply.
SensoWash
®
will start “Initialization” for about 15 seconds
when it is connected to the power supply. During this time the
“Status LED”
B
flashes green and only “Power”
A
on the seat
unit can work, all other operations will not work.
Switch SensoWash
®
on
Requirement: SensoWash
®
is in the “Standby mode”, the “Status
LED”
B
is red illuminated.
> Press “Power”
D
on the seat unit.
SensoWash
®
is now switched on.
The “Status LED”
B
is green illuminated.
All functions can be used.
6. Operating
. Switching the SensoWash
®
on / off
> Press “Power”
A
on the seat unit to switch on SensoWash
®
.
A green Status LED indicates “On mode”.
> Press “Power”
A
on the seat unit again to switch off SensoWash
®
.
A red Status LED indicates “Standby mode”.
. Shower functions
SensoWash
®
automatically cleans the retracted spray wand
before and after washing functions are used. The shower func-
tions terminate automatically after 2 minutes or immediately
when “Stop”
7
is pressed.