What to do if DURAVIT SensoWash i Plus Toilets remote control does not work?
If the remote control for your DURAVIT Toilet isn't working, begin by inserting batteries. If that doesn't solve the issue, the remote control may be defective, and further assistance may be needed.
What to do if water does not emerge from the spray wand of DURAVIT SensoWash i Plus Toilets?
If water isn't coming out of the spray wand of your DURAVIT toilet, the spray nozzle might be clogged; try cleaning it. Also, ensure the seat sensor has contact by sitting down and selecting the function again.
Why is the auto flush not working on my DURAVIT SensoWash i Plus Toilets?
If the auto flush on your DURAVIT toilet isn't working, first check if auto flush is deactivated and activate it. Also, if the seat sensor is dirty or wet, clean the surface. Auto flush only works when the user is seated and has been sitting for more than 6 seconds, so ensure that these conditions are met.
What to do if my DURAVIT Toilet does not flush?
If the DURAVIT Toilet does not flush, it might be due to a short interval between flushes, which is normal as the water takes approximately 25 seconds to refill. Alternatively, the stop valve might be closed, so ensure it is open. In case of a power or water supply failure, pour a bucket of water (8l) into the toilet, adding more if the water level is too low. If the problem persists, further assistance may be needed.
What to do if LED flashes red, green or orange on DURAVIT SensoWash i Plus Toilets?
If the LED flashes red, green, or orange, or if an indication tone is audible on your DURAVIT Toilet, it indicates a malfunction. Deactivate the seat unit, close the stop valve, and further assistance may be needed.
Why does the odor extraction stop automatically on DURAVIT SensoWash i Plus?
If the odor extraction on your DURAVIT toilet stops automatically, it is normal for the function to stop when the washing or warm air dryer function is active. The function will automatically restart when the washing/drying function stops.
What to do if there is water leakage from DURAVIT SensoWash i Plus?
If you notice water leakage from your DURAVIT toilet, further assistance may be required.
Why does the water spray suddenly stop on my DURAVIT Toilets?
If the water spray from the spray wand of your DURAVIT toilet suddenly stops, it could be normal as the function stops automatically after 2 minutes. Alternatively, the seat sensor might have lost contact; sit down and select the function again.
Why is the water spray intensity not stable on DURAVIT Toilets?
If the water spray intensity on your DURAVIT toilet isn't stable, the water filter might be clogged. Try cleaning the water filter.
Why does my DURAVIT SensoWash i Plus Toilets remote control not work?
If the remote control for your DURAVIT toilet isn't working, start by checking if batteries are inserted. If not, insert them. If the remote still doesn't work after inserting batteries, further assistance may be required.
Details and identification of the main toilet unit parts.
Information on the remote control unit and SensoWash app functionality.
Locating and identifying key functional areas and product sides.
Explanation of symbols used in the manual for guidance and warnings.
Essential safety instructions for user and product protection.
Guidance on using the manual, product operation, and LED indicators.
Steps for activating the unit, app setup, and remote battery replacement.
Lid operation, flush modes, and cleansing functions.
Setting spray wand, water, dryer, odor extraction, and user profiles.
Instructions for daily and general cleaning of the unit.
Care for spray wand, strainer, holiday mode, filter, and descaling.
Proper disposal methods for the product and batteries.
Solutions for problems related to LEDs, unit, remote, and functions.
Key technical data, including power, dimensions, and consumption.
To Next Page
General