Why is the auto flush not working on my DURAVIT SensoWash i Plus Toilets?
If the auto flush on your DURAVIT toilet isn't working, first check if auto flush is deactivated and activate it. Also, if the seat sensor is dirty or wet, clean the surface. Auto flush only works when the user is seated and has been sitting for more than 6 seconds, so ensure that these conditions are met.
What to do if my DURAVIT Toilet does not flush?
If the DURAVIT Toilet does not flush, it might be due to a short interval between flushes, which is normal as the water takes approximately 25 seconds to refill. Alternatively, the stop valve might be closed, so ensure it is open. In case of a power or water supply failure, pour a bucket of water (8l) into the toilet, adding more if the water level is too low. If the problem persists, further assistance may be needed.
Why auto flush does not work on my DURAVIT SensoWash i Plus Toilets?
If the DURAVIT Toilet auto flush does not work, ensure that the auto flush is activated. The seat sensor might also be dirty or wet, so clean the surface. Note that auto flush only works when someone is seated and has been sitting for more than 6 seconds.
How to fix water spray intensity if it is too weak in DURAVIT SensoWash i Plus Toilets?
If the water spray intensity of your DURAVIT Toilet is too weak, it might be set to low, so try adjusting it to medium or high. If the issue persists, it could indicate a water supply defect, and further assistance may be needed.
How to fix water spray intensity if it is not stable in DURAVIT SensoWash i Plus Toilets?
To address unstable water spray intensity in your DURAVIT Toilet, start by cleaning the water filter, as it might be clogged.
How to fix DURAVIT SensoWash i Plus seat heating if it does not work?
If the seat heating on your DURAVIT Toilet isn't working, ensure that the seat heating is activated.
How to adjust seat heating temperature in DURAVIT SensoWash i Plus?
To adjust the seat temperature on your DURAVIT Toilet, simply adjust the seat heating temperature settings.
How to fix weak water spray intensity on DURAVIT SensoWash i Plus Toilets?
If the water spray intensity of your DURAVIT toilet is too weak, it might be set to low. Try adjusting the water spray intensity to medium or high. If the issue persists, further assistance may be required.
What to do if my DURAVIT SensoWash i Plus unit does not work?
If your DURAVIT toilet unit isn't working, first ensure the seat unit is switched on (check if the LED is illuminated). If the seat unit is in standby mode (LED is red), switch it on.
Why is the water spray intensity not stable on DURAVIT Toilets?
If the water spray intensity on your DURAVIT toilet isn't stable, the water filter might be clogged. Try cleaning the water filter.
Details and identification of the main toilet unit parts.
Information on the remote control unit and SensoWash app functionality.
Locating and identifying key functional areas and product sides.
Explanation of symbols used in the manual for guidance and warnings.
Essential safety instructions for user and product protection.
Guidance on using the manual, product operation, and LED indicators.
Steps for activating the unit, app setup, and remote battery replacement.
Lid operation, flush modes, and cleansing functions.
Setting spray wand, water, dryer, odor extraction, and user profiles.
Instructions for daily and general cleaning of the unit.
Care for spray wand, strainer, holiday mode, filter, and descaling.
Proper disposal methods for the product and batteries.
Solutions for problems related to LEDs, unit, remote, and functions.
Key technical data, including power, dimensions, and consumption.
To Next Page
General