33
Pull the recoil start
The recoil start is located on the left side panel next to the air
lter. Pull the recoil handle slowly until resistance is felt, then
quickly pull the recoil handle until fully extended.
5.
Open choke
After the engine has started, push the choke left to the OPEN
position as the engine warms up.
6.
Turn breaker ON / Connect
The breaker is located on the right side of the front power
panel. Flip the breaker up to allow the power to ow to the
receptacles. Connect your devices to the receptacles on the
front panel. Start with the largest loads rst.
7.
CAUTION: Release the recoil handle only after the cord
has retracted. Releasing the recoil handle while extended
may cause harm to yourself or your equipment.
To Next Page
