Owner's Guide
24
Part: XXXXX Rev XX
Periodic Maintenance
Inlet water filter
If the inlet water filter
is covered with debris, the hot water may not run smoothly, or the unit may
put out cold water. Check and clean the filter as explained below.
* To avoid burns, wait until the equipment cools down before draining the water.
The appliance will remain hot after it is turned off.
1. Close the water supply valve.
2. Open all hot water fixtures.
3. With a bucket ready, remove the inlet water filter
(about 1 L. will drain out)
4. Take the inlet water filter. (See illustration to right).
5. Clean the inlet water filter with a brush under
running water.
6. Replace and close inlet water filter.
(Take care not to lose the packing.)
7. Close all hot water fixtures.
8. Open the water supply valve and check that
water does not leak from the inlet water filter.
Water Supply
Valve
* This water heater should be serviced by an authorised person at regular intervals not
exceeding 2 years.
Inlet
Packing
Inlet water filter
Ex. 21ENB5N
To Next Page
Loading...
