Dux sunpro 2F136S - Installation of the Tank; Safety

Owner’s Manual – Dux Electric Boosted Solar
2
H3161 025248 Rev. D
Installer’s Guide
Full and detailed installation instructions
are in the Installer’s Guide, included
inside the water heater’s carton.
Location
The water heater should be located as
close as possible to the most frequently
used hot water outlet. Ensure that the
data plate is clearly visible and provide
adequate access for service to the
thermostat, relief valve and anode.
Note: All models are equipped with a
sacricial anode, accessible through the
top cover. Allow 50% of the height of
the water heater for clearance above to
replace the anode.
We recommend a plinth be installed
under the water heater where the
water heater is subjected to wet
conditions
A properly drained overow tray must
be used where property damage could
occur from water spillage. (See AS/
NZS3500.4 for further details.)
Note: Warranty does not cover
consequential damage due to heater
leakage.
Safety
This appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning
use of the appliance by a person
responsible for their safety.
Children and animals should be
supervised to ensure that they do not
interfere with the appliance.
Model Numbers
Below is a list of model numbers and
their descriptions:
Tank
Model
Description
2F136S 250 Litre tank
2F136SD 250 Litre tank with Panel Management
3F136S 315 Litre tank
3F136SD 315 Litre tank with Panel Management
4F136S 400 Litre tank
4F136SD 400 Litre tank with Panel Management
Installation of the Tank