DVO ONYX DC - Disassembly Procedure; Initial Disassembly: Air Release and Top Cap Loosening

4 ONYX DC FULL SERVICEONYX DC FULL SERVICE
CAUTION - EYE HAZARD
Use a 2.5mm allen key to remove the low speed
knob. Then lift off the high speed compression ring.
Use needle nose pliers to remove the detent xture.
Be cautious of the detent balls falling out. Then use
a 32mm socket wrench to loosen the air side top
cap. You do not need to completely un-thread the
top caps.
Remove the air cap. Depress the valve to release the
air pressure.
A Disassembly
3.
2.
1.