Dymo LabelWriter Twin Turbo User Manual

5
4. Loading Labels
The LabelWriter Twin Turbo printer holds two label rolls, so you can print two
types of labels without having to change the label roll. For example, load address
labels on the left side and postage labels on the right side.
To load a label roll
1 Press the form-feed button to eject the labels that
protected the printer during shipment.
2 Open the top cover and remove any packing
material inside the label compartment.
3 Remove the label spool from inside the cover.
4 Hold the spool spindle in your left hand and place the
label roll on the spindle so that the labels feed from
underneath and the left edge of the label roll is flush
against the side of the spool. See Figure 8.
5 Place the spool guide onto the right side of the spool
and press the guide tightly against the side of the
label roll, leaving no gap between the roll and the spool. See Figure 8.
NOTE The label roll must fit snugly against both sides of the label
spool, with no gaps, to avoid drifting as the labels feed through the
printer. See Figure 8.
6 Insert the label spool into the slot in the printer cover with the
labels extending from underneath the roll. See Figure 9.
Figure 7
Spool
spindle
Spool
guide
Figure 8
Figure 9

Dymo LabelWriter Twin Turbo Specifications

General

Brand	Dymo
Model	LabelWriter Twin Turbo
Category	Label Maker
Language	English