dynabook TECRA A50-J - Page 2

3
7
9
6
4
1
5
8
2
1. Removing the Lithium Ion Battery (Main Battery, No coin cell battery)
Please refer to the information below for instructions regarding the identification and removal of the
lithium ion battery. Further maintenance instructions can be found in section 4.11 of the
TECRA A50-J, SATELLITE PRO A50-J/R50-J Maintenance Manual. Some tools are required in order
to remove this component. Once removed, these components should be recycled as per local
requirements.
To remove the battery, the base assembly must be removed first:
4.11.1 Removing the Cover Assembly and Base Assembly
To remove the Base Assembly, follow the steps below and refer to Figure 4- 4 to
Figure 4-5.
1. Close the display panel and turn the computer face down.
2. Remove the following screws securing the Cover Assembly and
the Base Assembly.
Figure 4-4 Removing the Base Assembly (1)
3. Separate the Base Assembly and Cover Assembly while
releasing the latches using a plectrum.