dynabook TECRA A50-J - Page 3

2
1
Base Assembly
2
3
Cover Assembly
Take care not to short circuit the terminals when removing the battery pack.
Similarly, do not drop, knock, scratch, disassemble, twist, or bend the battery pack.
Figure 4-5 Removing the Base Assembly (2)
4.12.1 Removing the Battery pack
To remove the battery pack, follow the steps below and refer to Figure 4-7 and Figure 4-8.
1. Disconnect the BATTERY HARNESS from the connector CN8021
on the SYSTEM board.
2. Remove the following screws and the battery pack.