dynabook TECRA A50-J - Page 20

Main
AUX
4.17 3G module
4.17.1 Removing the 3G module
To remove the 3G module, follow the steps below and refer to Figure 4-18.
1. Peel off the INSU SQUARE.
2. Disconnect the 3G ANTENNA cables from the connectors on the
3G MODULE. (red tube from “MAIN”)
3. Remove the following screw and disconnect the 3G MODULE from
the connector CN2610 on the USB board (FMERLT*).
Figure 4-18 Removing the 3G module
4.17.2 Installing the 3G module
To install the 3G module, follow the steps below.
1. Insert the 3G MODULE to the connector CN2610 on the USB
board. Secure the 3G MODULE with the screw.
2. Connect the 3G ANTENNA cables to the connectors on the
3G MODULE. (red tube to “MAIN”)
3. Stick a new INSU SQUARE in place.
3G Module
CN2630