dynabook TECRA A50-J - Page 21

Fan Harness
CN3380
Fan
CN3390
Figure 4-19 Installing the 3G module
INSU SQUARE
4.18 Fans
4.18.1 Removing the Fans
To remove the Fans, follow the steps below and refer to Figure 4-20.
1. Disconnect the Fan harness from the connector CN3380 and
CN3390
on the System Board (FMERSY*).
2. Remove the following screws and the Fans from the Cover Assembly.
Figure 4-20 Removing the Fans
4.18.2 Installing the Fans
To install the Fans, follow the steps below and refer to Figure 4-20.