dynabook TECRA A50-J - Page 22

Fin
S2 x 2.3CT
When removing the Fin, be sure to remove the screws in the reverse order of the
number marked on the Fin.
When installing the Fin, be sure to install the screws in the order of the number
marked on the Fin.
1. Set the Fans in place on the Cover Assembly and secure them with
the screws.
2. Connect the Fan harness to the connector CN3380 and CN3390
on the System Board (FMERSY*).
4.19 Fin
4.19.1 Removing the Fin
To remove the Fin, follow the steps below and refer to Figure 4-21.
1. Remove the following screws and then the Fin.
Figure 4-21 Removing the Fin
4.19.2 Installing the Fin
To install the Fin, follow the steps below and refer to Figure 4-21.
1. Set the Fin in place and secure it with the screws.