4.20
Click
pad
4.20.1
Removing the Click pad
To remove the click pad, follow the steps below and refer to Figure 4-22 to Figure 4-23.
1. Disconnect the Click Pad FFC and Fingerprint FFC from the
connectors on the Click Pad and the connectors CN9510 and
CN9550 on the System Board.
Figure 4-22 Removing the Click pad (1)
2. Remove the square cushion and peel off the gasket tape from the
Click Pad, and then peel off the Click Pad from the Cover Assembly.
Figure 4-23 Removing the Click pad (2)
4.20.2
Installing the Click pad
To install the Click pad, follow the steps below and refer to Figure 4-22 to Figure 4-24.
To Next Page
Loading...
