(For LTE models) When replacing the speaker with a new one, stick one
piece of Gasket on the speaker in place.
Gasket
Figure 4-27 Installing the Speaker
4.22
3G
antennas
4.22.1
Removing the 3G antennas
To remove the 3G antennas, follow the steps below.
1. Disconnect the SAR harness from the connector CN2650 on the
USB board (FMERLT*).
2. Open the stick tapes and remove the INSU on the 3G antenna (Aux).
3. Release the 3G antenna cables and SAR harness from the guides
on the Cover Assembly.
To Next Page
Loading...
