dynabook TECRA A50-J - Page 27

INSU
3G antenna cable
3G antenna cable
SAR Harness
CN2650
3G antenna (Aux)
3G antenna (Main)
Do not reuse the removed 3G antennas. Be sure to use new 3G antenna.
Figure 4-28 Removing the 3G antennas (1)
4. Peel off the 3G antennas from the Cover Assembly.
Figure 4-29 Removing the 3G antennas (2)
4.22.2 Installing the 3G antennas
To install the 3G antennas, follow the steps below and refer to Figure 4- 28 to Figure
4-29.
1. Stick new 3G antennas (AUX/Main) in place.
2. Arrange the 3G antenna cables and SAR harness in place on
the Cover Assembly, and fix them with the stick stapes.
3. Stick one piece of INSU on the 3G antenna (Aux).
4. Connect the SAR harness to the connector CN2650 on the USB
board (FMERLT*).