DYNACO PAS-4 User Manual

11
PAS-4 Specifications
Phono Section
GAIN: 40 dB
RIAA ACCURACY: +/- .5 dB from 20 Hz to 20 kHz
PHONO OVERLOAD: 500mV RMS @ 1kHz
MAXIMUM OUTPUT CAPABILITY: 60V RMS @ 1kHz
THD:
50V RMS @ 20kHz (for 1% THD)
less than .025% @ 2V RMS Output
INPUT IMPEDANCE: 47k shunted by 10pF
TAPE OUTPUT IMPEDANCE: 2k
NOISE: -86 dB below 10mV RMS Input
ABSOLUTE PHASE: Non-Inverting
TUBE COMPLEMENT: 2ea 6DJ8 (6922); 2ea 12AX7 (ECC83)
Line Section
GAIN: 18.5 dB
FREQUENCY RESPONSE:
2 Hz to 150 kHz (nominal)
(-3 dB, 20 k ohm load)
MAXIMUM OUTPUT: 40V RMS (for 1% THD)
THD: .025% @ 2V RMS Output
INPUT IMPEDANCE: 25k nominal (all inputs)
OUTPUT IMPEDANCE: 40 ohms
NOISE: -90 dB below 2V RMS Output
ABSOLUTE PHASE: Inverting
SLEW RATE: 40 V/µs
TUBE COMPLEMENT: 2ea 6DJ8 (6922)
Electrical / Mechanical
POWER REQUIREMENTS: 100, 115, or 230 VAC @ 50/60 Hz
POWER CONSUMPTION: 45 Watts
DIMENSIONS: 17" Wide, 3.75" High, 12" Deep
NET WEIGHT: 12 lbs.
SHIPPING WEIGHT: 14 lbs.

DYNACO PAS-4 Specifications

General

Brand	DYNACO
Model	PAS-4
Category	Amplifier
Language	English