4
Rear Panel Inputs and Outputs
Inputs - Phono
These inputs will accommodate "moving magnet" or high output "moving coil" cartridges which have
output levels of 1.0mV or higher.
In the lower right hand corner of the rear panel is the preamp's chassis ground terminal. This thumbscrew
is provided for attaching the separate ground wire often provided on turntables. (see Minimizing System
Noise on page 11)
Inputs - Tuner, CD, Video, Aux., Tape 1 & 2
These inputs receive standard line (high level) input signals from other equipment. The Tape Inputs of the
PAS-4 connect to Line Outputs (Play) on tape decks.
Tape Outputs
Signals sent to these outputs are at line level. (Phono signals are first amplified and equalized). Tape
Outputs are unaffected by external processing circuits, the Mono switch, the Volume control, or the
Balance control. The preamp's Tape Outputs connect to the tape deck(s) Line (Record) Inputs .
Preamplifier Main Outputs
Two pairs of outputs are provided for your power amplifier(s). The two left channel RCA jacks are
connected directly together inside of the PAS-4, as is the right channel pair.
EQ (External Processing Loop)
"EQ Out" are line level outputs which can be connected to the inputs of an external signal processor such
as an equalizer, time delay, or noise reduction unit. "EQ In" are for line level inputs coming from the signal
processor outputs.
FUSE
AC Line Fuse: 2 Amp Fast-Blow - 100 or 115 VAC
1 Amp Fast-Blow - 230 VAC
PUSH TAB TO RELEASE FUSE HOLDER
120
120120
120
To remove the AC line fuse, use a small screwdriver to push forward the tab near the center of the
Power Entry Module.
Always remove the power cord when accessing the AC line fuse.
To Next Page
Loading...
Need help?
General
