Need help?Do you have a question about the Dynacord CMS 1000 Owner‘s and is the answer not in the manual?
Guidelines for qualified personnel performing maintenance and repairs.
Procedures for unpacking the mixer and details of the warranty policy.
Guidance on proper placement, ventilation, and electrical connections.
Details on connecting low-impedance microphones via XLR.
Information on connecting line-level instruments and sound sources.
How to use the insert jack for external signal processors.
How to adjust input sensitivity for optimal signal levels.
Explanation of the 80 Hz low-cut filter for reducing rumble and feedback.
Details on the asymmetric filter for enhancing vocals and instruments.
How to shape audio signals using the equalizer controls.
How to route signals to the internal effects units FX1/FX2.
Configuration for monitor mixes and external FX units.
Adjusting the stereo image position of a sound source.
Function of the mute button for silencing channels.
How to use the Pre-Fader Listen function for monitoring.
Understanding the signal and peak level indicators.
Adjusting channel volume with the fader.
Connecting microphones to stereo input channels.
Connecting stereo or mono line-level sources.
Adjusting sensitivity for stereo microphone inputs.
Matching line level signals for stereo inputs.
Shaping audio signals with EQ on stereo channels.
Sending signals to FX units from stereo channels.
Sending signals to AUX 3/4 from stereo channels.
Adjusting the balance between left and right stereo channels.
Function of the mute button for stereo channels.
Pre-Fader Listen for stereo channels.
Understanding indicators for stereo signals.
Adjusting volume for stereo channels.
Overview of the two built-in stereo effects units.
How to set custom startup presets for effects.
Routing signals to the AUX/FX send sockets.
The effects unit program number display.
Buttons for selecting effect presets.
Routing FX outputs to monitor mixes.
Switching internal FX units on/off.
Pre-Fader Listen for effects sends.
Indicators for effect unit clipping.
Adjusting the amount of effect in the main mix.
Output connections for monitor amplifiers or external FX.
Using inserts for external processors on AUX channels.
Selecting pre or post-fader signal for AUX channels.
How to use the feedback suppression filter.
Muting the Aux-Send output signal.
Pre-Fader Listen for master bus.
Controlling monitor system volume.
Using the graphic equalizers for master or AUX.
Indicator for the mixer's operational status.
Meter display for output levels.
Function of the standby switch for muting outputs.
Pre-Fader Listen for the stereo master signal.
Adjusting main output levels.
Assigning equalizers to master or AUX buses.
Balanced mono output for monitoring or subwoofers.
Setting mono output level and routing.
Connecting headphones for monitoring.
Adjusting headphone volume.
Outputs for connecting recording devices.
Inputs for playback devices.
Adding 2Track signal to the main mix.
Routing 2Track signal to monitor bus.
Main balanced stereo outputs.
Using inserts for external processors on master path.
Connecting footswitches for effect control.
Connecting a gooseneck lamp.
Description of the main power switch and startup sequence.
Choosing between balanced and unbalanced audio cables.
Procedures for setting input levels and adjusting tone controls.
How to adjust master and channel faders for the main output.
Setting up monitor mixes using AUX channels and feedback filter.
General| Brand | Dynacord |
|---|---|
| Model | CMS 1000 Owner‘s |
| Category | Music Mixer |
| Language | English |
To Next Page