Need help?Do you have a question about the Dynacord PowerMate 600 and is the answer not in the manual?
General| Stereo Line Inputs | 2 |
|---|---|
| Type | Powered Mixer |
| Power Amplifier Output | 2 x 300W @ 4Ω |
| EQ | 3-band |
| Power Output | 2 x 300 Watts (4 Ohms) |
| Frequency Response | 20 Hz - 20 kHz |
| THD | < 0.005% |
Guidelines for qualified personnel performing maintenance and repairs.
Instructions for unboxing, checking contents, and warranty registration.
Guidance on placing the unit and making necessary audio and power connections.
Details on connecting and using low-impedance microphones with phantom power.
Connecting electronic instruments and high-level signal sources to line inputs.
Adjusting input sensitivity for optimal signal levels and S/N ratio.
Shaping audio signals using frequency band controls for tone adjustment.
Routing signals to effects units and monitor mixes.
Positioning signals in stereo and monitoring signal presence and peaks.
Setting individual channel volume levels and creating the overall mix.
Connecting stereo instruments and mono sources to stereo channels.
Adjusting input signal levels for optimal integration into the mixer.
Adjusting tone controls for shaping audio signals within frequency bands.
Routing summed stereo signals to FX and AUX buses.
Adjusting stereo signal balance for left/right output distribution.
Monitoring signal presence and peak levels for stereo channels.
Simultaneous volume adjustment for stereo input channels.
Understanding the display and selecting effect presets using UP/DOWN buttons.
Customizing initial effect programs upon device startup.
Using UP/DOWN buttons to select and step through effect presets.
Switching internal FX units on/off and monitoring status with LED.
Monitoring effect unit signal levels to prevent clipping.
Adjusting the amount of effect signal added to the main mix.
Output for monitoring amplifier or active stage monitors.
Adding effect signals to the monitor mix.
Adjusting the overall volume for the monitor system.
Summed post-fade L/R signal for additional monitoring or PA applications.
Muting all outputs to mute amplifiers and speakers.
Adjusting the output level of the summed L/R master signal at the MONO OUTPUT.
Connecting headphones for monitoring and adjusting volume level.
Pre-fader L/R signals for connecting to recording devices.
Inputs for connecting tape decks, CD players, or sub-mixers.
Mixing 2Track return signals into main or auxiliary buses.
Post-fader L/R signals for feeding external amplifiers or active systems.
Inputs for directly operating the internal power amplifiers.
Connecting a footswitch for remote control of FX units.
Monitoring power amplifier status: Protect, Limit, and Power ON.
Adjusting overall sound with a 7-band stereo graphic equalizer.
Monitoring L/R master output levels with 8-segment LED chains.
Adjusting the output signal levels for the left and right main outputs.
Professional SPEAKON connectors for loudspeaker system connections.
Mains switch for powering the unit on/off and fuse holder.
Advice on choosing and using high-quality cables for reliable operation.
Choosing flexible, high-quality cables with SPEAKON plugs for speakers.
Choosing between balanced and unbalanced cables for LF wiring.
Step-by-step guide for setting up a sound reinforcement system.
Steps for adjusting input levels and EQ for optimal sound.
Creating the basic mix using channel and master faders, and FX units.
Adjusting auxiliary sends and effects for monitor mix.
To Next Page
