Dynacord PSX 850 User Manual

Describes input channels, equalizer, and stereo connectivity of the mixer.

Details the built-in digital effects, master controls, and tape I/O.

Explains PCA processor power amplifiers and SpeakON connectors.

Describes XLR mic inputs and unbalanced line inputs for mono channels.

Controls for input sensitivity, peak indication, and frequency adjustment.

Details on EQ continuation, AUX send, and effect send controls.

Controls for stereo positioning and individual channel volume adjustment.

Describes stereo input channels for various signal sources.

Controls for input sensitivity, peak indication, and frequency adjustment for stereo channels.

Jacks for external loops and meters showing power modulation.

Thermal protection, limiter status indicators, and main volume controls.

Jacks for feeding stereo signals in and taking master bus signal out.

Controls for adjusting line input mixing and line output signal level.

Jacks for feeding signals into the master bus and sending signals to external units.

Controls for master send level and mixing AUX return signal.

Selection of 16 effect programs and controls for delay time and repeats.

Mechanism for switching effects on/off, including foot switch, and effect return fader.

Sockets for playing back tape recordings and sending master signal for recording.

Controls for output signal from TAPE SEND and volume of tape playback.

Central switch for 48V phantom power for microphone inputs.

Mains switch and indicators for unit readiness and operation.

Details on SPEAKON connectors, power ratings, and speaker polarity checks.

Specifications for single channel output power, dynamic headroom, and frequency response.

Data on amplitude non-linearities (THD) and noise levels.

Details on power supply, rated voltage, and input socket characteristics.

Specifications for output sockets, load impedance, and output levels.

Schematic representation of the internal signal path and component connections.