DYNAMIC DIAMOND TOOLING Beast - Page 36

4.3.7 Running the Machine Overview
CHECKLIST
 nsure the machine is plugged in to the correct power suppl
 nsure the vacuum hose is connected and the vacuum turned 
 nsure ST switch is in its upper most position
 nsure SD CTL switch does not eceed 7
 ith the machine flat on the floor ensure that the dust shroud is flat to the floor
and has a good seal on the floor
 nsure that the grinding head LL BBBL is in the centered position
 Set the operator handle to the most comfortable working height and tilt using the
handle adjustment settings
 ush the handle downwards to lift the machine about 1 cm 4 from the ground
 ress the STAT button
 Lower the machine down to the floor and begin GIDIG
Page 30
Dynamic Diamond Tooling
DDG 1220 User Manual