DYNAMIC DIAMOND TOOLING Beast - 2 Unning the Machine

4.2.6 Running the Machine
4.2.6.1 START
How to start the machine
 nsure that the power plug and dust collector hose are connected to the
machine
 Turn the dust collector  if used
 Set the Speed Control nob to its lowest speed setting
 Make sure that the ST button 4 is in its upper most position If not
release it b turning it a uarter turn clockwise until it rises
 ush the handle downwards to lift the machine about 1 cm 4 from the
ground
 ress the STAT 3 button
 Lower the machine down to the floor
4.2.6.2 STOP
How to stop the machine
 ress the ST 4 button
 ait for the machine to come to a complete stop before letting go of the handle
 Turn FF the dust collector if used
4.2.6.3 Adjusting grinding speed
Turn the SD CTL knob 2 clockwise to increase the grinding speed and
counter clockwise to decrease the grinding speed
4.2.6.4 Change grinding direction
se the L switch 1 to change the rotation of the motor and thereb selecting the
grinding direction Turn the machine FF and ensure that it has come to a complete stop
and then restart in the selected direction
Page 29
Dynamic Diamond Tooling
DDG 1220 User Manual